Please read the main instructions before commencing, then refer to this supplement.
These mountings have been designed for applications where it is not possible to lift the bike
by employing the normal 'beam' method in pairs, due to obstructions or uneven surfaces such as
the exhaust system or crankcase falling below the frame line of the bike.
They can be fitted on the front or rear beam mount to support the bike, typically by the legs of
the raised centre stand or the engine crankcase. This is done usually in pairs and can be
individually adjusted to differing heights to suit the contour of the engine casing.
A set comprises of two mountings complete with 'u' bolts that secure the bike frame but can also
be used without these providing an alternative form of stabilizing is employed.
For example, by the beam mount 'j' bolts or quality 'ratchet type' strapping.
This design allows for mounting in many different ways and has a range of height extension from (zero to 5in)
Please note. The diagram below shows four mountings this is for illustration only.
Page Top